EN
RISHBIN CO., LTD

Causes and Countermeasures of Failures of Unwinding Device of Slitter



In the slitter, the unwinding device plays an important role in the whole slitting and cutting operation. If the unwinding device fails, a lot of effects will be caused. Experts have explained the common failures and the maintenance methods of the unwinding device as follows, hoping it can be useful.

For the unwinding device, once the unwinding head can not expand or contract, it can not be used to unwind normally, which is the most troublesome. The cause of this problem can mainly divided into two aspects. On the one hand, it is maybe because the unwinding device's hydraulic pressure tightens and the output circuit of the solenoid valve fails, so that the electromagnet can not operate normally. For this reason, it is necessary to check the circuit diagram and exam whether the output fuses of the solenoid valve are burned or not, if they are damaged, replace them in time.

On the other hand, it is because the oil pressure of the tightener of the unwinding head is so small that the tension mechanism wears, which makes the tension piece loose and can not function normally. It can be seen from this point that the hydraulic oil in the equipment must be replaced regularly to maintain a good consistency, and we should also strengthen the maintenance of the unwinding head to avoid the occurrence of the problem.


  • Decoiling Leveling Shear Production Line

    Decoiling Leveling Shear Production Line

    September 3, 2018The decoiling and leveling production line is also referred to as the decoiler machine in the industry. The decoiler machine is divided into slitting and cross-cutting according to the direction of c...view
  • Brief Introduction of Slitting Process

    Brief Introduction of Slitting Process

    November 22, 2018For the operation of slitting machine, the slitting process includes many aspects. For example, when we operate the slitters, we must pay attention to the preparation before operation. We should also ...view
  • Reasons and Countermeasures for Defects in Cut To Length Line Processing

    Reasons and Countermeasures for Defects in Cut To Length Line Processing

    March 13, 2019(1) knife prints: knife prints caused by the inner edge angle of the disc cutter on the surface of the steel strip. It occurs in the edge thickness of the knife, continuous or intermittent knife print...view
  • Hydraulic, Pneumatic And Lubricating System

    Hydraulic, Pneumatic And Lubricating System

    May 14, 2018This production line has a set of hydraulic stations, it is specially designed for HJ-2*1000-00 leveling units, which can meet the requirements of every unit in the production line.The hydraulic valve...view
  • Metal Strip Leveling Crosscutting Production Line: Electrical System

    Metal Strip Leveling Crosscutting Production Line: Electrical System

    May 14, 2018The metal strip leveling crosscutting production line adopts three phase 50HZ and 380V AC power supply. The control part of the electrical system and the main circuit part are isolated by the control ...view
  • Metal Strip Leveling Crosscutting Line

    Metal Strip Leveling Crosscutting Line

    May 14, 2018The metal strip leveling cross-cutting line is used to expand and straighten the rolled metal strip, crosscut according to the required length, and pile up orderly in stacks. The unit adopts gas, hydr...view